Next, once I had all these sorted, I had enough for two sets. Both my sons and I went through and on two occasions found the same bump codes with same serial number, but different figure
I just don't understand why Lego makes this so difficult other than monetary gain. I spent over an hour sorting and making a chart to speed up the sort against one of the serial numbers. I found there were two figures that were very close with the bump codes, but not until I couldn't locate the 16th, I looked at the biggest pile of dupes, and found some in the pile had a hard to find bump code that distinguished it. Can't imagine anyone doing this in the store! It might be easier buying the whole set on ebay if your free time is limited.
I would imagine, Lego will eventually remove any ways to determine, I remember series 2 was just dealing with UPC codes, which seemed difficult at the time.
Hope this helps anyone save some time...




